Installation guide
Step 1 : Surface Preparation
The first step is to prepare the surface to be clean from dirt, dust, mold, oil, soap scum and any other contaminants. To do so, use a suitable cleaning product for your surface and scrub away any contaminants that are present. Rinse thoroughly with clean water and spray BIOSAVER Surface Preparation spray onto the surface evenly. Scrub the surface once again thoroughly and leave the solution on for another 5-10 minutes. Once the time is up, rinse well with clean water and wipe the surface dry.
Caution! If the surface is not thoroughly clean, the remaining contaminants can negatively impact the adhesion between the coating and the substrate which then leads to a lower lifetime of the product.
Step 2: Mixing
Remove the sticker seal on top of the container. To remove the lid, cut the silicone seal around the lid using a metal scraper. It is very important at this step to properly scrape off the anti-slip granules from the bottom of the container, failure in doing so may result in a lower Anti-slip resistance. Mix the solution and the granule until homogeneity is achieved.
